Home › How To Repair Insignia Flex Charge Port

How To Repair Insignia Flex Charge Port

Written By Tremper Morstraut Wednesday, February 16, 2022 Add Comment Edit

Turn off the power to your tablet to avoid injury.

Turn off the ability to your tablet to avert injury.
Position the tablet so that the screen is face down and the power push is located in the upper left hand corner.
Hold down the ability push button for 5 seconds until the tablet powers down.

Remove the back casing from the screen by sliding a credit card or a similarly thin but firm object in between the casing and the screen.

Remove the back casing from the screen by sliding a credit card or a similarly sparse just firm object in between the casing and the screen.
You may need to use a spudger to initially create separation between the screen and the casing.
Run this object effectually the perimeter of the tablet until there is separation between the casing and the screen.
Remove the dorsum casing and set aside.

Peel record off of ribbon connectors. Starting at the power push, work clockwise around the tablet.

To remove the photographic camera ribbon cable, elevator the flap using a spudger.
Pull the ribbon directly back to release it.

Remove the second ribbon cable past prying up the black flap using a spudger.
Pull the ribbon cable horizontally straight away from the battery.

Remove the final ribbon cable by pulling back the 2 black tabs on either side of the ribbon cable.
Pull the ribbon horizontally directly away from the battery.

Unscrew the thirteen four.75mm screws around the perimeter of the tablet using a PH 00 screwdriver.

Unscrew the iv 3.75mm screws and plastic washers using a PH 00 screwdriver.
Lift upwardly the circuit board.

Unscrew the final 2 screws that were underneath the circuit lath.
These screws are near the charging port and USB adapter.
These screws are besides iii.75mm and tin exist interchanged with the second set of screws but.

Lift the circuit board and black internal mounting piece away from the screen.
Set up the circuit board bated.
Be careful of the soldered antenna as you separate the pieces.
Exist careful of the soldered ribbon that is connected to the power source. This ribbon is fragile.

Slide the spudger in between the silver screen and the black edge

Pry up the LCD display and lift it away from the plastic screen.

Source: https://www.ifixit.com/Guide/Insignia+Flex+8+Screen+Replacement/40191

Posted by: grimeswint1956.blogspot.com

0 Response to "How To Repair Insignia Flex Charge Port"

Post a Comment

Subscribe to: Post Comments (Atom)